TIUB WELL

TIUB WELL

Boreing Water construction Sdn Bhd

PROJECK MANAGEMENT,BUILDING AND CIVIL ENGINEERING CONSTRUCTION COMPANY,GROUND WATER EXPLORATION TIUB WELL DRILLING SERVICE MONITOR WELL SERVICE ROR IRRIGATION

Mineral Exploration Rigs

Mineral Exploration Rigs

TIUB WELL

A tube well is a type of water well in which a long 100–200 mm (5 to 8 inch) wide stainless steel tube or pipe is bored into an underground aquifer. The lower end is fitted with a strainer, and a pump at the top lifts water for irrigation. The required depth of the well depends on the depth of the water table.

Temporary reservoir

A small reservoir of water is made at the outlet of the tube well. This reservoir is used for different usage of water by the local population.

Drive mechanism

In the past, the pump was driven by large diesel engines. However, nowadays electric motors are used, as they are a much cheaper source of power.

Casing

The tube well casing houses the inlet, cylinder, piston valves and rising main of a "down-the-hole" type hand pump. Casing to support the external surfaces of the borehole against collapse may be needed, either temporarily or permanently, and is often made of PVC which is both cheap and inert.

Seepage down the tube well bore is prevented by the sanitary seal. Seepage from the ground above the aquifer is excluded by the lengths of plain casing. Water to be pumped is admitted through slots in the lower lengths of casing.

Water abstracted from aquifers in relatively soft ground usually contains sand or silt particles, which are liable to cause rapid wear to pump valves and cylinders (and dissatisfaction among consumers). Methods of preventing these particles from reaching the pump are of two general types, screening and sand/gravel packing.

Screening

The drawing shows slots in the PVC casing which can be cut on site, using a hacksaw. More elaborate, and far more compact, screens are available commercially; some can be bolted on to pump inlets. Materials used include woven wire and man-made fabric; the latter can be wrapped around the pump inlet assembly. Screening is nearly always needed in some form.

Sand/gravel packing

The drawing shows graded sand and gravel, which is placed from the top of the borehole. More compact, pre-bonded, packs of sand and/or gravel are available commercially; some of these can also form part of the pump inlet assembly. Sand and/or gravel packing is meant to eliminate particles from the water before they reach the screen and would otherwise have passed through the screen.

Ground Water Safety

The introduction of tube wells has led to major arsenic poisoning in Bangladesh. High concentrations of arsenic occur naturally in the soil in some areas of Bangladesh. The wells were drilled into aquifers which contained high levels of this naturally occurring arsenic.

.

.

.

.

.

.

Monday, November 14, 2011

Air Bawah Tanah


Absrak - Air bawah tanah di dalam batuan metasedimen di Malaysia yang terekah adalah sumber air berpotensi untuk air minuman dan kegunaan industri. Industri pertanian, pembotolan mineral air, pembuatan dan padang-padang golf adalah diantara industri yang mengambil air tersebut daripada batuan terekah. Sebanyak lima puluh lapan telaga tiub kepunyaan syarikat-syarikat swasta yang beroperasi dibeberapa tempat di pantai barat semenanjung Malaysia telah diperiksa tentang penghasilan dan kualiti airnya. Penggerudian dengan kaedah putaran tekanan udara telah digunakan untuk membina telaga sehingga kedalaman maksimum 200m.

No comments:

Mesin Gerudi Brothermus

Mesin Gerudi Brothermus

My Blog List

Mesin Gerudi

Mesin Gerudi

Mesin Gerudi Tiub Well

Mesin Gerudi Tiub Well
Mesin gerudi yang direkacip teroleh Brother Mus.Mula dibena pada okt 2011 dan siap pada 30 dec 2011.Kekuatan ini boleh mencecah ke 200 kaki. Dan mempunya pusingan 120/m.